Page 1 of 1
Can you use more than 1 memory stick on a firmware?
Posted:
Tue Apr 07, 2009 1:12 pmby C4LV1N
I have 3.71 m33-2 and I have a 2gb memory stick. I am running out of memory and was going to buy a new one. Do I have to do the magic memory stick process again, or do I just pop it in and start saving files?
Posted:
Tue Apr 07, 2009 1:42 pmby Devil May Cry
Make sure you format the blank Memory Stick in the PSP first so it puts the directories in there for you. Then it's just like your other Memory Stick. No MMS required.
Posted:
Tue Apr 07, 2009 3:26 pmby C4LV1N
Ah. So formatting doesn't just clear out all the files on your psp, it also adds all the stuff required for the firmware. Thanks for the help
Posted:
Tue Apr 07, 2009 7:01 pmby roxfox64
No, Formatting just sets up an allocation type.
Posted:
Mon May 11, 2009 4:45 pmby 3rdEyeBlind
unless, you have a situation like me, where my battery is always in boot mode, but have timemachine on, then you need to have it on all the time. But i dont think this is the case for you, once you load CFW on there, it stays. so you can add games and such to the other and just run them.
Btw, please if you do play games and use homebrew and play with themes alot and stuff, go to the store and buy a 256 mb card for like 3 bucks, this will ensure that you always have a backup incase you brick